Zanussi ZCI68300XA Manuel D’Utilisation

Make sure that the wall is made of a solid

material. If not, you need to make the wall

sufficiently strong to hold the weight.

Make sure that the surface behind the

appliance is smooth.

2. Put the appliance in the middle of the space

between the cupboards. 

If the space is larger than the width of the

appliance, you must adjust the side

measurement.

3. Install the anti-tilt protection (A)

approximately 77 mm below the top surface

of the appliance and 50 mm from the left or

right side of the appliance into the circular

hole on the bracket. Screw it into the wall.

50 mm

77 mm

4. Check that the anti-tilt protection (A) fits

minimum 20 mm into the hole in the rear

wall of the appliance (B) when you push the

appliance.

The manufacturer is not responsible

if you do not follow the safety

precautions from Safety chapters.

This appliance is supplied without a main plug

or a main cable.

• The recommended cross-section area is six

square millimetres (6 mm²).

• When you refit the mains terminal cover,

make sure that the lower tabs are located

inside the bottom edge of the aperture,

before you fix the two screws into the top

edge of the mains terminal cover.

• Make sure that the cover is securely

fastened.

To open the cover of terminal board

obey the procedure in opposite

sequence.

Do not remove blanking plates.

Make sure that the links are fitted as shown.

N

N

N

L

L