Cisco Cisco Unified MeetingPlace Audio Server Guide De Montage
Cisco MeetingServer 5.1 Installation Planning Guide
58
Cisco Systems
March 2003
Worksheet 3-3b MeetingPlace LAN Requirements
(Hong Kong)
Action
Description
9
9
9
9
1.
Cable/Connector
Requirements
Requirements
Connection from MeetingPlace Server to your network:
For twisted-pair Ethernet, 100Base-TX. Provide an RJ-
45 connector. 10Base-T will work, but is not
recommended. This cable is customer supplied.
45 connector. 10Base-T will work, but is not
recommended. This cable is customer supplied.
Connection from MeetingPlace IP Access Blade to your
network:
network:
For twisted-pair Ethernet, 100Base-TX. Provide an RJ-
45 connector. This cable is Latitude supplied.
45 connector. This cable is Latitude supplied.
Note: Set your switch to auto-negotiate. If your switch does
not support auto-negotiation, it is recommended that it be set
to 100 BaseT Full Duplex
not support auto-negotiation, it is recommended that it be set
to 100 BaseT Full Duplex
2.
Desktop
Requirements
Requirements
Provide a desktop system connected to your LAN with the
following minimum configuration:
following minimum configuration:
133 MHz or higher Pentium (for Windows 2000)
Windows 98, NT 4.0 or later, or 2000
15MB Available disk space
16MB RAM (24MB RAM for Windows NT or 256MB
RAM for Windows 2000)
RAM for Windows 2000)
Network Interface Card
3.
Host Name
Name for MeetingPlace on your network
4.
MeetingPlace
IP Address
IP Address
Address of the MeetingPlace host on the network
Note: When you request your IP address and host name,
ensure that your LAN Manager adds this to the name
server(s).
ensure that your LAN Manager adds this to the name
server(s).
5.
Subnet Mask
Mask that completes the address for the MeetingPlace host
6.
Broadcast Address
Address used to broadcast packets on the local LAN segment
7.
Default Gateway
Address of the gateway that will accept and route
information to the other networks
information to the other networks
8.
SNMP
IP Address
IP Address
IP address for which traps will be sent for trap communities
9.
Name Server
Ensure all workstations running MeetingTime utilize a name
server (DNS/WINS or local “hosts” table)
server (DNS/WINS or local “hosts” table)
10.
NTP Server IP
Address
Address
It is recommended you time synchronize your MeetingPlace
system with a Network Time Protocol (NTP) server.
Worksheet 4-8 describes the NTP settings.
system with a Network Time Protocol (NTP) server.
Worksheet 4-8 describes the NTP settings.