Cisco Cisco Unified MeetingPlace Audio Server Manuel De Maintenance
7-16
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 7 Installing a Shadow Server
Testing the switchover
Changing the shadow server back to shadow server mode
After completing the test switchover, the shadow server must be reconfigured as a shadow server.
Step 1
If not already connected, access the shadow server’s CLI by following the procedures in
and
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
Type
down
and press Enter.
Step 4
Type
y
and press Enter to confirm that you want to bring the system down.
Step 5
Once the server is down, type
setup
and press Enter.
Step 6
Type
5
and press Enter to select shadow server mode.
Step 7
Enter the necessary information as you are prompted.
Step 8
Once the setup is complete, type
restart enable
and press Enter.
Note
If the “net” command is run at any point after the “setup” command, the “setup” configuration is
overwritten and must be redone.
overwritten and must be redone.
Bringing the primary server back online
Step 1
and
Step 2
Log in as technician. The tech$ prompt appears.
Step 3
Type
restart enable
and press Enter.
Step 4
Once the system is back up, type
swstatus
and press Enter.
Step 5
Confirm that the shadow server, unit 9, has reconnected.
Step 6
Log into the shadow server via the CLI.
Step 7
Type
swstatus
and press Enter.
Step 8
Confirm that the shadow server shows itself as being connected to the primary server, unit 0.
Step 9
Wait at least 15 minutes.
Step 10
If there are meetings taking place on the primary server, log onto the shadow server via the CLI.
At the CLI, type
gwstatus
and press Enter to confirm the gateways have reconnected.
At the CLI, type
spanstat -s
and press Enter to confirm the spans are up.
Log into MeetingTime to confirm you can connect.
Table 7-4
Post-switchover Tasks (continued)
X
Task