Cisco Cisco Unified Enhanced Media Processor Software Guide D’Installation Rapide
Configuring Call Control for Cisco Unified MeetingPlace
How to Configure Call Control for Voice Conferencing
11
Step 8
Configure all other required fields appropriately for your current deployment.
If you configured a Calling Search Space to block unwanted dial-out calls, then apply the Calling Search
Space accordingly to the SIP trunk.
Space accordingly to the SIP trunk.
Tip
For field descriptions, select Help > This Page.
Step 9
Select Save.
Step 10
Repeat this task so that both of the following servers are configured with SIP trunks that point to each
other:
other:
•
Cisco Unified Communications Manager 4.x or 5.x
•
Cisco Unified Communications Manager 6.1 or a later release
What to Do Next
Proceed to the
Configuring Cisco Unified Communications Manager 4.x or 5.x: Route Patterns
Use this procedure to configure route patterns to enable Cisco Unified Communications Manager 4.x or
5.x to route calls that are placed to Cisco Unified MeetingPlace phone numbers. The route patterns
associate the Cisco Unified MeetingPlace phone numbers with one of the following, depending on your
deployment:
5.x to route calls that are placed to Cisco Unified MeetingPlace phone numbers. The route patterns
associate the Cisco Unified MeetingPlace phone numbers with one of the following, depending on your
deployment:
•
Inter-cluster trunk to the Cisco Unified Communications Manager Release 6.1 (or a later release)
server that provides front-end signaling for Cisco Unified MeetingPlace
server that provides front-end signaling for Cisco Unified MeetingPlace
•
(Cisco Unified Communications Manager 5.x only) SIP trunk to the Cisco Unified
Communications Manager Release 6.1 (or a later release) server that provides front-end signaling
for Cisco Unified MeetingPlace
Communications Manager Release 6.1 (or a later release) server that provides front-end signaling
for Cisco Unified MeetingPlace
Before You Begin
•
Complete the
.
•
Complete one of the following items, depending on your deployment:
–
–
•
Write down each of the following phone numbers from the Cisco Unified MeetingPlace
Administration Center:
Administration Center:
–
Access phone numbers configured on the
–
Direct Inward Dial (DID) numbers—only if you enable DID through the
field