Cisco Cisco Firepower Management Center 2000 Manuel Technique
alphanumeric characters, with no spaces. The use of hyphens is allowed.Network address -
The network address can be either static IPv4 or IPv6 addresses. You can also use DHCP
for IPv4, or IPv6 stateless auto-configuration.DNS information - You must identify at least
one Domain Name System (DNS) server, and you can also set the domain name and search
domain.NTP information - You can enable Network Time Protocol (NTP) and configure the
NTP servers in order to set the system time.
Enter the system install command in order to install the system software image:
The network address can be either static IPv4 or IPv6 addresses. You can also use DHCP
for IPv4, or IPv6 stateless auto-configuration.DNS information - You must identify at least
one Domain Name System (DNS) server, and you can also set the domain name and search
domain.NTP information - You can enable Network Time Protocol (NTP) and configure the
NTP servers in order to set the system time.
Enter the system install command in order to install the system software image:
asasfr-boot >system install [noconfirm] url
Include the noconfirm option if you do not want to respond to confirmation messages.
Replace the url keyword with the location of the .pkg file. Here is an example:
Replace the url keyword with the location of the .pkg file. Here is an example:
asasfr-boot >system install http://<HTTP_SERVER>/asasfr-sys-5.3.1-152.pkg
Verifying
Downloading
Extracting
Package Detail
Description: Cisco ASA-FirePOWER 5.3.1-152 System Install
Requires reboot: Yes
Do you want to continue with upgrade? [y]: y
Warning: Please do not interrupt the process or turn off the system. Doing so
might leave system in unusable state.
Upgrading
Starting upgrade process ...
Populating new system image
Reboot is required to complete the upgrade. Press 'Enter' to reboot the system.
(press Enter)
Broadcast message from root (ttyS1) (Mon Jun 23 09:28:38 2014):
The system is going down for reboot NOW!
Console session with module sfr terminated.
3.
Note: When the installation is complete, the system reboots. Allow ten or more minutes for
the application component installation and for the ASA SFR services to start. The output of
the show module sfr command should indicate that all processes are Up.
the application component installation and for the ASA SFR services to start. The output of
the show module sfr command should indicate that all processes are Up.
Configure
This section describes how to configure the FirePOWER software and the FireSIGHT
Management Center, and how to redirect traffic to the SFR module.
Management Center, and how to redirect traffic to the SFR module.
Configure the FirePOWER Software
Complete these steps in order to configure the FirePOWER software:
Open a session to the ASA SFR module.
Note: A different login prompt now appears because the login occurs on a fully-functional
module.Here is an example:
Note: A different login prompt now appears because the login occurs on a fully-functional
module.Here is an example:
ciscoasa# session sfr
Opening command session with module sfr.
Connected to module sfr. Escape character sequence is 'CTRL-^X'.
Sourcefire ASA5555 v5.3.1 (build 152)
Sourcefire3D login:
1.
Log in with the username admin and the password Admin123.
2.