Cisco Cisco IOS Software Release 12.0(1)T Guide De Dépannage
ROMmon Recovery Procedure for the 7000 (RP)
Series
Series
Document ID: 15081
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
ROMmon Recovery Procedure
Step−by−Step
Prerequisites
Requirements
Components Used
Conventions
ROMmon Recovery Procedure
Step−by−Step
Download using the Boot Image and a Trivial File Transfer Protocol (TFTP) Server
Use Another Router to Get a Valid Cisco IOS Software Image into the PCMCIA Card
Related Information
Use Another Router to Get a Valid Cisco IOS Software Image into the PCMCIA Card
Related Information
Introduction
This document describes how to recover a 7000 (RP) Series Router stuck in ROMmon (
rommon # >
prompt
).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The outputs used in this document were tested on the Cisco 7000 router with RP module.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
ROMmon Recovery Procedure
Step−by−Step
Follow the instructions provided below: