Cisco Cisco IOS Software Release 12.0(1)T Guide De Dépannage

Introduction
 Prerequisites
      Requirements
      Components Used
      Conventions
 Procedure
 Related Information

This page explains how to recover a Cisco 1000 Series Router stuck in ROMmon (

rommon # >

 prompt).

There are no specific requirements for this document.

The information in this document is based on the hardware version below:

Cisco 1000 Series Router

• 

The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.

For more information on document conventions, see the Cisco Technical Tips Conventions.

Follow the instructions below to perform ROMmon recovery:

Issue the dev command to see which devices are available on your router:

rommon 1 > dev

Devices in device table: 

        id  name

    eprom:  eprom

    flash:  PCMCIA slot 1

rommon 2 > 

1.