Cisco Cisco Content Security Management Appliance M1070 Guide De Montage
5
6
Temporarily Change Your IP
Address for Remote Access
To remotely configure the Cisco M190 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M190, without changing the IP address. If
you use the serial console, proceed to section
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M190, without changing the IP address. If
you use the serial console, proceed to section
below.
Note
Make a note of your current IP configuration settings
as you will need to revert to these settings after you
finish the configuration.
as you will need to revert to these settings after you
finish the configuration.
For Windows
The exact steps depend on your operating system version.
Step 1
Go to the Start menu and choose Control Panel.
Step 2
Click Network and Internet, then Network and Sharing
Center.
Center.
Step 3
Click the Change adapter settings link.
Step 4
Right-click Local Area Connection and choose
Properties.
Properties.
Step 5
Click Internet Protocol Version 4, then choose
Properties.
Properties.
Step 6
Note your current settings.
Step 7
Select Use the Following IP Address.
Step 8
Enter the following changes:
–
IP Address: 192.168.42.43
–
Subnet Mask: 255.255.255.0
–
Default Gateway: 192.168.42.1
Step 9
Click OK and OK again to exit the dialog box.
M190_QSG.fm Page 5 Thursday, March 31, 2016 4:32 PM