Cisco Cisco MDS 9000 NX-OS Software Release 6.2

Cisco MDS 9250i Multiservice Fabric Switch

Cisco MDS 9000 8-port 10-Gbps Fibre Channel over Ethernet (FCoE) Module 

Cisco MDS 9000 48-port 8-Gbps Advanced Fibre Channel Switching Module 

Cisco MDS 9000 32-port 8-Gbps Advanced Fibre Channel Switching Module

Cisco MDS 9000 48-port 16-Gbps Fibre Channel Switching Module

You cannot bring up these modules if these features are already configured. You should completely remove all configurations 
that include these features before you attempt to bring up these modules. In addition, you cannot configure these features after 
you bring up these modules.

In addition, the following software features are not supported or are changed in Cisco MDS NX-OS Release 6.2(9c):

Fibre Channel Security Protocol (FC-SP) is currently not supported on Cisco MDS 9250i Multiservice Fabric Switch.

Local switching is not supported on the Cisco MDS 9700 Series Director, but continues to be supported on the Cisco MDS 
9500 Series.

Online Health Management System (OHMS)—The Generic Online Diagnostics (GOLD) system provides diagnostics for 
the Cisco MDS 9700 Series Director instead of the OHMS. In Cisco NX-OS Release 6.2, the GOLD system does not 
provide any support for automation of corrective actions, such as rebooting modules based on error thresholds.

OHMS is supported on Cisco MDS 9500 Series directors, Cisco MDS 9250i Multiservice Fabric Switch, 
Cisco MDS 9148S Multilayer Fabric Switch, and Cisco MDS 9148 Multilayer Fabric Switch.

Cisco NX-OS Release 6.2 does not support the following hardware:

Cisco MDS 9134 Fabric Switch

Cisco MDS 9124 Fabric Switch

Cisco MDS 4-Gbps Fabric Switch for HP c-Class BladeSystem

Cisco MDS 4-Gbps Fabric Switch for IBM BladeCenter

This section lists the limitations and restrictions. The following limitations are described:

The copy bootflash:runnig-config.ascii startup-config command that was deprecated in an earlier Cisco NX-OS release is 
enabled from Cisco NX-OS Release 6.2(1).