Cisco Cisco IOS Software Release 12.3(4)T
How to Configure Private Line Automatic Ringdown for Trading Turrets
4
Cisco IOS Release 12.3(4)T
3.
controller t1 slot/port
4.
framing {sf | esf}
5.
clock source {line | internal}
6.
linecode {ami | b8zs}
7.
ds0-group ds0-group-number timeslots timeslot-list type {e&m-delay-dial | e&m-fgd |
e&m-immediate-start | e&m-wink-start | ext-sig | fgd-eana | fgd-os | fxo-ground-start |
fxo-loop-start | fxs-ground-start | fxs-loop-start | none}
e&m-immediate-start | e&m-wink-start | ext-sig | fgd-eana | fgd-os | fxo-ground-start |
fxo-loop-start | fxs-ground-start | fxs-loop-start | none}
8.
voice-port slot/port:ds0-group-number
9.
timeouts wait-release {seconds | infinity}
10.
timing hookflash-input milliseconds
11.
connection {{plar [tied] | tie-line | plar-opx} digits | trunk digits [answer-mode]}
12.
exit
13.
dial-peer voice tag {pots | vofr | voip}
14.
destination-pattern [+] string [T]
15.
session target ipv4: destination-ip-address
16.
no vad
17.
exit
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
controller t1
slot/port
Example:
Router(config)# controller t1 1/0
Enters controller configuration mode and identifies the
controller type as T1, and specifies a slot and port for
configuration commands that apply to the T1 interface.
controller type as T1, and specifies a slot and port for
configuration commands that apply to the T1 interface.
Step 4
framing
{sf | esf}
Example:
Router(config-controller)# framing esf
Specifies a frame type.
•
The controller command must be entered before this
command can be used.
command can be used.
•
The frame type can be specified as sf for super frame or
esf for Extended Superframe for T1 controllers.
esf for Extended Superframe for T1 controllers.