Cisco Cisco IOS Software Releases 12.2 MC
3
Release Notes for Cisco MGX-RPM-1FE-CP Back Card for Cisco IOS Release 12.2(8)MC2d
OL-2920-05
System Configuration Requirements
In addition, you must configure a connection between the PVC and the FRSM as well as a connection
between the FRSM and the PVC.
between the FRSM and the PVC.
For detailed information about the MGX-RPM-1FE-CP back card and its implementation in the IP-RAN
solution, see the MGX-RPM-1FE-CP Back Card Installation and Configuration Note.
solution, see the MGX-RPM-1FE-CP Back Card Installation and Configuration Note.
System Configuration Requirements
The MGX-RPM-1FE-CP requires the following system configuration:
•
Cisco IOS 12.2(8) MC1 or a later Cisco IOS Release 12.2 MC image is installed on the
corresponding Cisco MGX 8850 RPM-PR.
corresponding Cisco MGX 8850 RPM-PR.
•
The FE interface is configured via the Cisco IOS software command line interface.
Memory Recommendations
Determining the Software Version
To determine the version of Cisco IOS software copied on the RPM-PR, access the CLI of the RPM-PR
and enter the show version command:
and enter the show version command:
rpm> show version
Cisco Internetwork Operating System Software
IOS (tm) RPM Software (RPM-JS-M), Version 12.2(8)MC2, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
Upgrading to a New Software Release
For information about copying Cisco IOS images to RPM-PR Flash memory, see the RPM-PR
Installation and Configuration document.
Installation and Configuration document.
For general information about upgrading to a new Cisco IOS software release, refer to Software
Installation and Upgrade Procedures located at the following URL:
Installation and Upgrade Procedures located at the following URL:
http://www.cisco.com/warp/public/130/upgrade_index.shtml
Table 1
Memory Recommendations for the Cisco MGX 8850 RPM-PR
Platform
Software Image
Flash
Memory
Recommended
Memory
Recommended
DRAM
Memory
Recommended
Memory
Recommended
Runs From
Cisco MGX-RPM-1FE-CP
rpm-js-mz
32 MB Flash
256 MB DRAM
RAM