Cisco Cisco IOS Software Releases 12.2 MC
5
Release Notes for Cisco MGX-RPM-1FE-CP Back Card for Cisco IOS Release 12.2(8)MC2d
OL-2920-05
New Features in the Cisco IOS Release 12.2 MC Software
ppp multilink
multilink-group 1
end
On the MGX-RPM-1FE-CP back card;
interface Virtual-Template2
bandwidth 1536
no ip address
keepalive 1 2
no peer default ip address
ppp multilink
multilink-group 101
end.
Note
In the MGX-RPM-1FE-CP backcard configuration example, only the keepalive interface command and
configuration recommendation is specific to implementation in an IP RAN solution.
configuration recommendation is specific to implementation in an IP RAN solution.
This new feature is identified by CSCdy78207.
New Features in Cisco IOS Release 12.2(8)MC2c
The following new features are introduced in Cisco IOS Release 12.2(8)MC2c:
•
•
•
16 Multilink Interfaces Support
The MGX-RPM-1FE-CP now supports up to 16 multilink interfaces.
The additional interface support requires that the number of RTP compression-connections for an
interface be managed using the ip rtp compression-connections command.
interface be managed using the ip rtp compression-connections command.
Up to 6000 compression-connections can be allocated with up to 1000 RTP compression-connections
per multilink interface. If more than 6000 compression-connections are configured, an error message
similar to the following will display whenever an interface comes up and it does not receive all of its
requested compression-connections:
per multilink interface. If more than 6000 compression-connections are configured, an error message
similar to the following will display whenever an interface comes up and it does not receive all of its
requested compression-connections:
00:22:32:%IXP1200_CP-1-HPRX_CTX_MEM_POOL:Out of resources for Multilink5. Requested 1000
compression-connections, Obtained 900.
While an interface that does not obtain enough compression-connections will still function, the
compression will be limited to the number of connections that it did obtain. If no
compression-connections were obtained, all packets will be sent decompressed.
compression will be limited to the number of connections that it did obtain. If no
compression-connections were obtained, all packets will be sent decompressed.