Cisco Cisco IOS Software Release 12.2(8)T
ATM Software Segmentation and Reassembly (SAR)
Configuration Tasks for AAL2 Trunking with CCS
33
Cisco IOS Release 12.2(8)T
Configuring MGCP POTS Dial Peer
To configure MGCP POTS dial peer on the Cisco 2600 series and the Cisco 3660, complete the
following commands beginning in global configuration mode:
following commands beginning in global configuration mode:
Configuring DS-0 Group and Channel Group for CCS
To configure a DS-0 group and the channel group for CCS on the Cisco 2600 series and the Cisco 3660,
complete the following commands beginning in global configuration mode:
complete the following commands beginning in global configuration mode:
Command
Purpose
Step 1
Router(config)# dial-peer voice number pots
Enters the dial-peer configuration mode for the
POTS dial-peer.
POTS dial-peer.
Step 2
Router(config-dial-peer)# application MGCPAPP
Initiates the MGCP protocol for the voice ports.
Step 3
Router(config-dial-peer)# port slot/port:ds0-group
This command associates the dial peer with a
specific logical interface.
specific logical interface.
The value of slot is the router location where the
voice port adapter is installed. Valid entries are from
0 to 3.
voice port adapter is installed. Valid entries are from
0 to 3.
The value of port indicates the voice interface card
location. Valid entries are 0 or 1.
location. Valid entries are 0 or 1.
Each defined DS0 group number is represented on a
separate voice port. This allows you to define
individual DS0s on the digital T1/E1 card.
separate voice port. This allows you to define
individual DS0s on the digital T1/E1 card.
Step 4
Router(config-dial-peer)# exit
Exits from the dial-peer configuration mode.
Command
Purpose
Step 1
Router(config)# controller {T1 | E1} slot/port
Enters controller configuration mode for the
controller at the specified slot/port location. Valid
values for slot and port are 0 and 1.
controller at the specified slot/port location. Valid
values for slot and port are 0 and 1.
Step 2
Router(config-controller)# mode ccs frame-forwarding
Configures the controller to support CCS
transparent signaling.
transparent signaling.