Cisco Cisco IOS Software Release 12.2(33)SRE

To display information about Any Transport over MPLS (AToM) virtual circuits (VCs) and static 
pseudowires that have been enabled to route Layer 2 packets on a router, use the show mpls l2transport 
vc command in privileged EXEC mode.

show mpls l2transport vc [vcid vc-id | vcid vc-id-min vc-id-max] [interface name 

[local-circuit-id]] [destination ip-address | name] [detail]

Privileged EXEC

(Optional) A specific VC ID to display. 

(Optional) The VC ID number.

(Optional) A range of VCs to display. The range is from 1 to 4294967295. 

(Optional) The interface or subinterface of the router that has been enabled to 
transport Layer 2 packets. Use this keyword to display information about the VCs 
that have been assigned VC IDs on that interface or subinterface.

(Optional) The name of the interface or subinterface. 

(Optional) The number assigned to the local circuit. This argument value is 
supported only with the following transport types: 

For Frame Relay, enter the data-link connection identifier (DLCI) of the 
permanent virtual circuit (PVC).

For ATM adaptation layer 5 (AAL5) and cell relay, enter the virtual path 
identifier (VPI) or virtual channel identifier (VCI) of the PVC. 

For Ethernet VLANs, enter the VLAN number. 

(Optional) The remote router. 

(Optional) The IP address of the remote router. 

(Optional) The name assigned to the remote router.

detail 

(Optional) The detailed information about the VCs.

12.1(8a)E

This command was introduced.

12.0(21)ST 

This command was integrated into Cisco IOS Release 12.0(21)ST.

12.0(22)S

This command was implemented on the Cisco 10720 router. 

12.0(23)S

The interface and destination keywords were added.

12.2(14)S

This command was integrated into Cisco IOS Release 12.2(14)S. 

12.2(14)SX

This command was implemented on the Supervisor Engine 720. 

12.2(14)SZ 

This command was integrated into Cisco IOS Release 12.2(14)SZ. 

12.2(15)T

This command was integrated into Cisco IOS Release 12.2(15)T. 

12.2(18)S 

This command was implemented on Cisco 7304 routers.