Cisco Cisco IOS Software Release 12.2(35)SE

The /reload option reloads the system after downloading the image unless the configuration has been 
changed and not saved.

For //location, specify the IP address of the TFTP server.

For /directory/image-name.tar, specify the directory (optional) and the image to download. Directory 
and image names are case sensitive.

This example shows how to download an image from a TFTP server at 198.30.20.19 and to overwrite 
the image on the switch:

Switch# archive download-sw /overwrite 

You can also download the image file from the TFTP server to the switch and keep the current image by 
replacing the /overwrite option with the /leave-old-sw option.

For additional recovery procedures, see the “Troubleshooting” chapter in the software configuration 
guide for this release.

You can assign IP information to your switch by using these methods:

The Express Setup program, as described in the switch getting started guide.

The CLI-based setup program, as described in the switch hardware installation guide.

The DHCP-based autoconfiguration, as described in the switch software configuration guide.

Manually assigning an IP address, as described in the switch software configuration guide.

If you are upgrading a Catalyst 3750 or a 2950 switch running Cisco IOS Release 12.1(11)AX, which 
uses the IEEE 802.1x feature, you must re-enable IEEE 802.1x after upgrading the software. For more 
information, see the 

When upgrading or downgrading from Cisco IOS Release 12.2(18)SE, you might need to reconfigure 
the switch with the same password that you were using when running Cisco IOS Release 12.2(18)SE. 
This problem only occurs when changing from Cisco IOS Release 12.2(18)SE to any other release. 
(CSCed88768)