Cisco Cisco IOS Software Release 12.2(35)SE

You can assign IP information to your switch by using these methods:

The Express Setup program (refer to the hardware installation guide.)

The CLI-based setup program (refer to the hardware installation guide.)

The Dynamic Host Configuration Protocol (DHCP)-based autoconfiguration (refer to the software 
configuration guide.)

Manually assigning an IP address (refer to the software configuration guide.)

If you are upgrading a switch running Cisco IOS Release 12.1(11)AX, which uses the 802.1x feature, 
you must re-enable 802.1x after upgrading the software. For more information, see the 

These sections describe the new supported hardware and the new software features provided in this 
release: 

This release supports the Catalyst 3750-24PS and Catalyst 3750-48PS PoE switches. For a list of all 
supported hardware, see the 

. 

For a list of default settings after initial switch configuration, including default settings that are changed 
in Cisco IOS Release 12.2(18)SE, refer to Table 1-1 in Chapter 1 of the software configuration guide. 

For a list of commands that have the same function in Cisco IOS Release 12.1(19)EA1 or earlier but 
different syntax in Cisco IOS Release 12.2(18)SE, refer to Table 1-2 in Chapter 1 of the command 
reference. 

Cisco IOS Release 12.2(18)SE contains these new features or enhancements:

User-defined and Cisco-default Smartports macros for creating custom switch configurations for 
simplified deployment across the network.

Smartports macros are referred to as SmartPort macros in the software configuration guide and 
in the command reference.

Support for the Catalyst 3750-24PS and the Catalyst 3750-24PS PoE switches. These switches can 
provide power to connected Cisco pre-standard and IEEE 802.3af-compliant powered devices from all 
10/100 Ethernet ports if the switch detects that there is no power on the circuit.