Cisco Cisco IOS Software Release 12.2(35)SE

These sections describes the hardware and software requirements for using the device manager:

 lists the minimum hardware requirements for running the device manager.

SFP modules (Catalyst 3750, 3560, 
and 2970)

1000BASE-CWDM

5

, -LX, SX, -T, -ZX

100BASE-FX MMF

6

Cisco IOS Release 12.2(18)SE

Cisco IOS Release 12.2(20)SE

SFP modules (Catalyst 2960)

1000BASE-BX, -CWDM, -LX/LH, -SX, -ZX

100BASE-BX, FX, -LX

Cisco IOS Release 12.2(25)FX

XENPAK modules

7

XENPAK-10-GB-ER, XENPAK-10-GB-LR, 
and XENPAK-10-GB-SR

Cisco IOS Release 12.2(18)SE

Redundant power systems

Cisco RPS 675 Redundant Power System

Cisco RPS 300 Redundant Power System 
(supported only on the Catalyst 2960 switch)

Cisco Redundant Power System 2300

Supported on all software releases

Supported on all software releases

Cisco IOS Release 12.2(35)SE and later 
(not supported on Catalyst 2970 
switches)

1.

PoE = Power over Ethernet

2.

SFP = small form-factor pluggable

3.

Each uplink port is considered a single interface with dual front ends (RJ-45 connector and SFP module slot). The dual front ends are not redundant 
interfaces, and only one port of the pair is active.

4.

Cisco EtherSwitch service module

5.

CWDM = coarse wavelength-division multiplexer

6.

MMF = multimode fiber

7.

XENPAK modules are only supported on the Catalyst 3750G-16TD switches.

Intel Pentium II

1

1.

We recommend Intel Pentium 4.

64 MB

2

2.

We recommend 256-MB DRAM.

256

1024 x 768

Small