Cisco Cisco IOS Software Release 12.2(35)SE
16
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(46)SE
OL-16493-01
Documentation Updates
After you have entered the eigrp stub router configuration command, only the eigrp stub
connected summary command takes effect. Although the CLI help might show the receive-only
and static keywords and you can enter these keywords, the switch always behaves as if the
connected and summary keywords were configured.
connected summary command takes effect. Although the CLI help might show the receive-only
and static keywords and you can enter these keywords, the switch always behaves as if the
connected and summary keywords were configured.
Updates to the System Message Guide
These sections contains these updates to the system message guide:
New System Messages
These system messages were added:
Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation
The switch cannot create the specified managed object. [chars] is the object name.
Recommended Action
No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]
informing virtual switches of dual-active: new active id [enet], old id [enet]
informing virtual switches of dual-active: new active id [enet], old id [enet]
Explanation
Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,
which means that all virtual switches are in a dual-active scenario. The interface is informing virtual
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first
[enet] is the new active ID. The second [enet] is the ID that it replaces.
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first
[enet] is the new active ID. The second [enet] is the ID that it replaces.
Recommended Action
No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
registry
Explanation
The switch could not add a function to the registry. [chars] is the registry name.
Recommended Action
No action is required.
Error Message %PM-6-EXT_VLAN_ADDITION: Extended VLAN is not allowed to be configured
in VTP CLIENT mode.
in VTP CLIENT mode.
Explanation
The switch did not add a VLAN in VTP client mode.
Recommended Action
Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section in the system message guides.
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section in the system message guides.