Cisco Cisco IOS Software Release 12.2(35)SE

This section contains these documentation updates:

These are the updates to the software configuration guide:

This information about the dot1x timeout tx-period seconds interface configuration command is 
incorrect: 

The range for seconds is from 5 to 65535.

The correct range is from 1 to 65535 seconds.

This information in the “MAC Address-Table Move Update” section of the “Understanding Flex 
Links and the MAC Address-Table Move Update” chapter is incorrect:

The switch then starts forwarding traffic from the server to the PC through port 4, which reduces 
the loss of traffic from the server to the PC.

This is the correct information:

Switch A does not need to wait for the MAC address-table update. The switch detects a failure 
on port 1 and immediately starts forwarding server traffic from port 2, the new forwarding port. 
This change occurs in 100 milliseconds (ms). The PC is directly connected to switch A, and the 
connection status does not change. Switch A does not need to update the PC entry in the MAC 
address table.

This caution was added to the “Configuring System Message Logging” chapter of the software 
configuration guide.

Logging messages to the console at a high rate can cause high CPU utilization and adversely affect how 
The private-vlan mapping interface configuration command only affects private-VLAN traffic that is 
Layer 3 switched.