Cisco Cisco IOS Software Release 12.2(35)SE
23
Release Notes for the Catalyst 3750 Metro Switch Cisco IOS Release 12.2(46)SE
OL-16490-01
Documentation Updates
•
CSCso10374
If the customer provider-edge switch is configured for IEEE 802.1Q tunneling and Layer 2 protocol
tunneling, and the Catalyst 3750 Metro switch is using VLAN-based EoMPLS on the
service-provider VLAN, Layer 2 protocol packets from the provider-edge switch are now correctly
forwarded in both directions.
tunneling, and the Catalyst 3750 Metro switch is using VLAN-based EoMPLS on the
service-provider VLAN, Layer 2 protocol packets from the provider-edge switch are now correctly
forwarded in both directions.
•
CSCso22855
If you specify the router ID before entering the autonomous-system autonomous-system-number
address-family configuration command, the router ID is no longer lost when the switch reloads.
address-family configuration command, the router ID is no longer lost when the switch reloads.
•
CSCso22883
Any form of the passive-interface command entered in one instance propagates to all configured
address-family instances for the same EIGRP routing process.
address-family instances for the same EIGRP routing process.
•
CSCso23165
When the ip pim sparse-mode and ip wccp web-cache redirect in configuration commands are
applied on a global table interface, traffic is now sent to multicast receivers
applied on a global table interface, traffic is now sent to multicast receivers
•
CSCso72052
An end host no longer remains in the guest VLAN after IEEE 802.1X authentication.
•
CSCso92450
The ip sla responder global configuration command no longer has to be removed and then added
again to the running configuration after you reload a switch.
again to the running configuration after you reload a switch.
•
CSCsq09918
A debug exception error that causes the switch to fail no longer occurs. In previous releases, this
failure occurred when one or more switches were configured in the same Resilient Ethernet Protocol
(REP) segment.
failure occurred when one or more switches were configured in the same Resilient Ethernet Protocol
(REP) segment.
•
CSCsr18073
The IP SLA Ethernet MIB no longer returns the incorrect value for the sum of squares of the positive
jitter from destination to source.
jitter from destination to source.
•
CSCsr55949
When IEEE 802.1x is enabled on the switch, EAP notification packets are no longer dropped.
Documentation Updates
This section contains these documentation updates:
•
•
•