Cisco Cisco IOS Software Release 12.2(35)SE

These system messages are not yet in the system message guide: 

Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars] 

The switch cannot create the specified managed object. [chars] is the object name. 

No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars] 
informing virtual switches of dual-active: new active id [enet], old id [enet] 

Port Aggregation Protocol (PAgP) received a new active ID on the specified interface, 

which means that all virtual switches are in a dual-active scenario. The interface is informing virtual 
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first 
[enet] is the new active ID. The second [enet] is the ID that it replaces.

No action is required.

Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars] 
registry 

The switch could not add a function to the registry. [chars] is the registry name.

No action is required.

Error Message %PM-6-EXT_VLAN_ADDITION: Extended VLAN is not allowed to be configured 
in VTP CLIENT mode. 

The switch did not add a VLAN in VTP client mode. 

Copy the message exactly as it appears on the console or in the system log. 

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to 
look for similar reported problems. If you still require assistance, open a case with the TAC, or 
contact your Cisco technical support representative, and provide the representative with the gathered 
information. For more information about these online tools and about contacting Cisco, see the 
“Error Message Traceback Reports” section in the system message guides.

These messages have been deleted:

Error Message %VQPCLIENT-2-INITFAIL: Platform-specific VQP initialization failed. 
Quitting 

Error Message %VQPCLIENT-2-IPSOCK: Could not obtain IP socket 

Error Message %VQPCLIENT-7-NEXTSERV: Trying next VMPS [IP_address]