Cisco Cisco IOS Software Release 12.2(27)SBC
QoS CLI Migration from PRE2 to PRE3
Information About QoS CLI Migration from PRE2 to PRE3
3
QoS CLI Migration from PRE2 to PRE3
PRE2 and PRE3 Command Line Interface Differences
lists the differences between the PRE2 and PRE3 command line interfaces (CLIs).
Table 1
PRE2 and PRE3 Command Line Interface Differences
Command
PRE2 Command
PRE3 Command
facility-alarm
facility-alarm core-temperature major 53
facility-alarm outlet-temperature major 58
facility-alarm core-temperature minor 45
facility-alarm outlet-temperature minor 50
facility-alarm core-temperature critical 85 facility-alarm outlet-temperature critical 85
Compatibility: On the PRE3, the alarm is set for the outlet temperature instead of the core
temperature alarm set on the PRE2. The default values for major, minor, and critical alarms are
53, 45, and 85 on the PRE2, and 58, 50, and 85 on the PRE3, respectively.
temperature alarm set on the PRE2. The default values for major, minor, and critical alarms are
53, 45, and 85 on the PRE2, and 58, 50, and 85 on the PRE3, respectively.
bandwidth
bandwidth value [bps | kbps | mbps | gbps] bandwidth value
Compatibility: On the PRE2, valid bandwidth values are from 1 to 2488320000 and by default
are expressed in kbps. On the PRE3, valid bandwidth values are from 1 to 2000000 and are
always expressed in kbps.
are expressed in kbps. On the PRE3, valid bandwidth values are from 1 to 2000000 and are
always expressed in kbps.
The PRE3 accepts the PRE2 bandwidth command only if it is used without the unit argument:
bps, kbps, mbps, or gbps. If the specified value is outside the PRE3 valid values range, the PRE3
rejects the PRE2 bandwidth command.
bps, kbps, mbps, or gbps. If the specified value is outside the PRE3 valid values range, the PRE3
rejects the PRE2 bandwidth command.
bandwidth-remaining
bandwidth-remaining ratio
bandwidth-remaining ratio
Compatibility: The PRE2 allows the bandwidth and bandwidth-remaining commands to be
part of the same class map or policy map. However, the PRE3 does not allow these commands
to coexist in a class map or policy map.
part of the same class map or policy map. However, the PRE3 does not allow these commands
to coexist in a class map or policy map.
priority
priority rate
priority
Compatibility: The PRE2 accepts the priority rate command as a hidden command. However,
the PRE3 does not accept the priority rate command.
the PRE3 does not accept the priority rate command.