Cisco Cisco IOS Software Release 12.2(25)S

To display Border Gateway Protocol (BGP) routes that failed to install in the Routing Information Base 
(RIB) table, use the show ip bgp rib-failure command in EXEC mode.

This command has no keywords or arguments.

EXEC

The following is sample output from the show ip bgp rib-failure command:

Router# show ip bgp rib-failure 

Network            Next Hop                      RIB-failure   RIB-NH Matches

10.1.15.0/24       10.1.35.5           Higher admin distance              n/a

10.1.16.0/24       10.1.15.1           Higher admin distance              n/a

 describes the significant fields shown in the display.

12.3

This command was introduced.

12.0(26)S

This command was integrated into Cisco IOS Release 12.0(26)S.

12.2(25)S

This command was integrated into Cisco IOS Release 12.2(25)S.

Network

IP address of a network entity.

Next Hop

IP address of the next system that is used when forwarding a packet 
to the destination network. An entry of 0.0.0.0 indicates that the 
router has some non-BGP routes to this network.