Cisco Cisco IOS Software Release 12.2(58)SE

CSCtg98453 

When you make port security changes on an interface, such as configuring aging time, violations, 
or aging type, error messages and tracebacks might appear.

There is no workaround.

CSCtl32991 

Unicast EIGRP packets destined for the switch are sent to the host queue instead of to the higher 
priority routing protocol queue.

This does not occur when packets are routed through the switch to another destination.

There is no workaround. 

CSCtl60247 

When a switch running Multiple Spanning Tree (MST) is connected to a switch running Rapid 
Spanning Tree Protocol (RSTP), the MST switch acts as the root bridge and runs per-VLAN 
spanning tree (PVST) simulation mode on boundary ports connected to the RST switch. If the 
allowed VLAN on all trunk ports connecting these switches is changed to a VLAN other than VLAN 
1 and the root port of the RSTP switch is shut down and then enabled, the boundary ports connected 
to the root port move immediately to the forward state without going through the PVST+ slow 
transition. 

There is no workaround.

CSCtl81217

When a switch is using a DHCP server to assign IP addresses and an interface on the switch has RIP 
enabled, if the switch reloads, the interface loses some RIP configuration (specifically RIP 
authentication mode and RIP authentication key-chain). This does not happen when the IP address 
is statically configured on the interface. The problem occurs only when you configure RIP before 
an IP address is assigned by the DHCP server.

There is no workaround, but you can use an embedded event manager (EEM) script to add the 
interface configuration commands on the interface:

CSCtn08650

If you try to use Device manager to upgrade the IP services image on the switch to Cisco IOS 
Release 12.2(58)SE, the upgrade might not successfully complete. It hangs at the step “Loading the 
tar file to the switch.”

The workaround is to use the CLI to upgrade the IP services image.