Cisco Cisco IOS Software Release 12.2(18)SXD
Supported Standards, MIBs, and RFCs
4
Cisco IOS Release 12.2(18)SXD
Supported Standards, MIBs, and RFCs
Standards
•
No new or modified standards
MIBs
•
No new or modified MIBs
RFCs
•
No new or modified RFCs
Prerequisites
The DFP agent subsystem has no prerequisites.
Configuration Tasks
To define the port number to be used by the DFP manager to connect to the IOS SLB DFP agent to
receive DFP reports, enter the following commands in order, beginning in global configuration mode:
receive DFP reports, enter the following commands in order, beginning in global configuration mode:
Command
Description
Step 1
Router(config)# ip dfp agent subsystem-name
Identifies a DFP agent subsystem and initiates
DFP agent configuration mode. See the ip dfp
agent command for more details.
DFP agent configuration mode. See the ip dfp
agent command for more details.
Step 2
Router(config-dfp)# interval seconds
(Optional) Configures a DFP agent weight
recalculation interval. See the interval (DFP
agent) command for more details.
recalculation interval. See the interval (DFP
agent) command for more details.
Step 3
Router(config-dfp)# password [0|7] password [timeout]
(Optional) Configures a DFP agent password for
MD5 authentication. See the password command
for more details.
MD5 authentication. See the password command
for more details.
Step 4
Router(config-dfp)# port port-number
Defines the port number to be used by the DFP
manager to connect to the DFP agent. See the port
(DFP agent) command for more details.
manager to connect to the DFP agent. See the port
(DFP agent) command for more details.
Step 5
Router(config-dfp)# inservice
Enables the DFP agent for communication with a
DFP manager. A DFP agent is inactive until both
of the following conditions are met:
DFP manager. A DFP agent is inactive until both
of the following conditions are met:
•
The DFP agent has been enabled using the
inservice (DFP agent) command.
inservice (DFP agent) command.
•
The client subsystem has changed the DFP
agent’s state to ACTIVE.
agent’s state to ACTIVE.
See the inservice (DFP agent) command for more
details.
details.