Cisco Cisco IOS Software Release 12.2(18)SXD

To display debugging messages for the Dynamic Feedback Protocol (DFP) agent subsystem, use the 
debug ip dfp command in user EXEC or privileged EXEC mode. To stop debugging output, use the no 
form of this command.

This command has no arguments or keywords.

No default behavior or values.

User EXEC or privileged EXEC mode

This command displays debugging messages for the DFP agent subsystem.

See the following caution before using debug commands:

Because debugging output is assigned a high priority in the CPU process, it can render the system 
unusable. For this reason, use debug commands only to troubleshoot specific problems or during 
troubleshooting sessions with Cisco technical support staff. Moreover, it is best to use debug 
commands during periods of lower network flows and fewer users. Debugging during these periods 
reduces the effect these commands have on other users on the system.

The following example configures a DFP agent debugging session:

Router# debug ip dfp agent

DFP debugging is on

The following example stops all debugging:

Router# no debug all

All possible debugging has been turned off

12.1(8a)E

This command was introduced.

12.2(14)S

This command was integrated into Cisco IOS Release 12.2(14)S.

12.3(4)T

This command was integrated into Cisco IOS Release 12.3(4)T.

12.2(18)SXD

This command was integrated into Cisco IOS Release 12.2(18)SXD.