Cisco Cisco 2106 Wireless LAN Controller
43
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 6.0.202.0
OL-31336-01
Caveats
Resolved Caveats
lists caveats resolved in controller software release 6.0.202.0.
CSCtj05569
Headline: WLC is not releasing the BIND for the 1st LDAP, next user fail auth
Symptom:
1. User1 authenticating, wlc binds with configured username wlc admin, search for
user1, user1 found in the tree, wlc binds with user1 to test password and user1 gets
authenticated.
user1, user1 found in the tree, wlc binds with user1 to test password and user1 gets
authenticated.
2. User2 authenticating, wlc does not bind with wlcadmin, rather keeps the bind of
user1 and search for user2 with user1 bind. search doesn't find user2 since user1
doesn't have search priv and authentication for user2 fails.
user1 and search for user2 with user1 bind. search doesn't find user2 since user1
doesn't have search priv and authentication for user2 fails.
3. The WLC is keeping the bind for the previous user and it is not releasing it.
Conditions: If the READ permission is not given to the users to search for the other
users in the LDAP account.
users in the LDAP account.
Workaround: When READ permission is provided to the User to search for other
user on the LDAP account, it does work. PS: This fix is provided only for J-MR1
release. This will not be fixed in H-MR as this is a new change and the earlier day-1
behavior no customer reported this issue. Also, this was discussed with escalation
team not to fix this in H-MR4.
user on the LDAP account, it does work. PS: This fix is provided only for J-MR1
release. This will not be fixed in H-MR as this is a new change and the earlier day-1
behavior no customer reported this issue. Also, this was discussed with escalation
team not to fix this in H-MR4.
CSCtg67029
Headline: 'show client tsm' does not display full output.
Symptom: 'show client tsm', web, and SNMP do not report full TSM information for
all clients.
all clients.
Conditions: This happens in a very big setup when the TSM reports fill up the
availability memory for TSM.
availability memory for TSM.
Workaround: Cleanup the TSM reports which are not required.
CSCto25030
Headline: AP hostname displays 31 characters after upgrading to 6.0 on WLC
Symptom: Access Point host-name displays 31 characters after upgrading to 6.0.
Symptom: Access Point host-name displays 31 characters after upgrading to 6.0.
Condition: Access Point initially configured for 32 characters for the host-name.
Post upgrade to 6.0 only 31 characters are shown when you run-config and show ap
summary commands.
Post upgrade to 6.0 only 31 characters are shown when you run-config and show ap
summary commands.
Workaround: Add 32 characters in the GUI.
Table 7
Open Caveats (continued)
ID Number
Description
Table 8
Resolved Caveats
ID Number
Caveat Title
CSCso22875
Access points get disconnected during code upgrade
CSCsw68997
HREAP AP VLAN mappings are mismatched.
CSCsv14863
Controller sends and displays channel 0 and power level 0 settings to AP
CSCsv34136
WLC should not enforce source port check on RFC3576 Disconnect-Request
CSCsv97224
Customer web not selected still user prompted with custom page