Cisco Cisco Email Security Appliance C160 Mode D'Emploi

Access to the CLI varies depending on the management connection method you chose in 

. The factory default username and password are listed next. Initially, only the 

admin user account has access to the CLI. You can add other users with differing levels of permission 
after you have accessed the command line interface for the first time via the admin account. (For 
information about adding users, see 

.) The System Setup Wizard asks you to 

change the password for the admin account. The password for the admin account can also be reset 
directly at any time using the password command. 

To connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 
192.168.42.42. SSH is configured to use port 22. Telnet is configured to use port 23. Enter the username 
and password below. 

To connect via a Serial connection: Start a terminal session with the communication port on your 
personal computer that the serial cable is connected to. Use the settings for serial port outlined in 

. Enter the username and password below. 

Log in to the appliance by entering the username and password.

Username: 

Password: 

For example: 

The CLI version of the System Setup Wizard basically mirrors the steps in the GUI version, with a few 
minor exceptions:

The CLI version includes prompts to enable the web interface.

The CLI version allows you to edit the default Mail Flow Policy for each listener you create. 

The CLI version contains prompts for configuring the global Anti-Virus and Outbreak Filters 
security settings.

The CLI version does not prompt you to create an LDAP profile after the system setup is complete. 
Use the 

ldapconfig

 command to create an LDAP profile.

To run the System Setup Wizard, type 

systemsetup

 at the command prompt.

login: admin

password: ironport

IronPort> systemsetup