Cisco Cisco Aironet 701e Access point Guide De Montage
3
Warning
This product relies on the building’s installation for short-circuit (overcurrent)
protection. Ensure that the protective device is rated not greater than:
20A. Statement 1005
protection. Ensure that the protective device is rated not greater than:
20A. Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an
explosive environment unless the device has been modified to be especially qualified for
such use. Statement 245B
explosive environment unless the device has been modified to be especially qualified for
such use. Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be
located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.
Statement 332
located at a minimum of 7.9 inches (20 cm) or more from the body of all persons.
Statement 332
Caution
Do not use plastic wall anchors to mount the access point on a ceiling because they will
not support the weight of the access point. The fasteners used must be capable of
maintaining a minimum pullout force of 20 lbs (9 kg).
not support the weight of the access point. The fasteners used must be capable of
maintaining a minimum pullout force of 20 lbs (9 kg).
Caution
This product and all interconnected equipment must be installed indoors within the same
building, including the associated LAN connections as defined by Environment A of the
IEEE 802.af Standard.
building, including the associated LAN connections as defined by Environment A of the
IEEE 802.af Standard.
Note
Use only with listed ITE equipment.
Note
Cisco Aironet 701E access points are designed for indoor use. If you install the access points
in an enclosure, make sure the enclosure is designed to maintain an operating temperature
between 32 and 104 degrees F (0 and 40 degrees C) and a humidity range between 10% and
90% (noncondensing). Failure to maintain these temperature and humidity ranges can cause
the unit to fail and void your warranty.
in an enclosure, make sure the enclosure is designed to maintain an operating temperature
between 32 and 104 degrees F (0 and 40 degrees C) and a humidity range between 10% and
90% (noncondensing). Failure to maintain these temperature and humidity ranges can cause
the unit to fail and void your warranty.