Cisco Cisco Aironet 1310 Access Point Bridge Guide De Montage
36
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
78-17634-01
Using a DC Power Source
Caution
Only a qualified electrician or service person should make and install the power cable with in-line fuse
supplying DC-power to the power injector.
supplying DC-power to the power injector.
Caution
To prevent damage to the access point or power injector, connect all coax cables from the power injector
to the access point and connect the power jack to the power injector before applying power.
to the access point and connect the power jack to the power injector before applying power.
The power plug has a screw-on cap to secure the power cable to the power injector. The mating power
plug is a Switchcraft 760K (see
plug is a Switchcraft 760K (see
).
Figure 15
Power Plug
Inline Power Fuse
When you mount the access point in a vehicle, an inline power fuse must be used in the positive (+)
power line going to the power injector.
power line going to the power injector.
Note
The inline power fuse must be listed and certified to the appropriate safety standards for the country
where the access point is installed.
where the access point is installed.
provides the inline power fuse requirements:
117002
Table 2
Inline Power Fuse Requirement
Vehicle Power Source
Inline Fuse (Slow-blow)
+12 VDC
1.7 A
+24 VDC
600 mA
+37.5 VDC
360 mA
+40 VDC
335 mA