Cisco Cisco Secure Access Control System 5.1
7
Release Notes for the Cisco Secure Access Control System 5.1
OL-18997-01
Installation and Upgrade Notes
•
Rack-mount kit
•
Cisco Information Packet
•
Warranty card
•
Regulatory Compliance and Safety Information for the Cisco 1121 Secure Access Control
System 5.1
System 5.1
Step 2
Go through the specifications of the CSACS 1121 Series appliance. For more details, refer to
.
Step 3
Read the general precautions and safety instructions that you must follow before installing the CSACS
1121 Series appliance. For more details, refer to
1121 Series appliance. For more details, refer to
and pay special attention to all the safety warnings.
Step 4
Install the appliance in the 4-post rack, and complete the rest of the hardware installation. For more
details on installing the CSACS 1121 Series appliance, refer to
details on installing the CSACS 1121 Series appliance, refer to
Step 5
Connect the CSACS 1121 Series appliance to the network and connect either a USB keyboard and Video
Graphics Array (VGA) monitor or a serial console to the serial port.
Graphics Array (VGA) monitor or a serial console to the serial port.
shows the back panel of
the CSACS 1121 Series appliance and the various cable connectors.
Note
For the initial setup, you must have either a USB keyboard and VGA monitor or a serial console
running terminal-emulation software.
running terminal-emulation software.
For more details, refer to
For information on installing ACS 5.1 on VMware, refer to
chapter in the Installation and Upgrade Guide for the Cisco Secure Access Control System 5.1.
Figure 1
CSACS 1121 Series Appliance Rear View
The following table describes the callouts in
.
Step 6
After completing the hardware installation, power up the appliance.
197065
1
8
4
4
3
7
2
6
5
1
AC power receptacle
5
(Blocked) Gigabit Ethernet 1
2
(Blocked) Gigabit Ethernet
6
(In Use) Gigabit Ethernet 0
3
Serial connector
7
USB 3 connector
4
Video connector
8
USB 4 connector