Cisco Cisco ASR 5700
Application Detection and Control Configuration
Configuring System for ADC ▀
ADC Administration Guide, StarOS Release 18 ▄
25
Step 2
Configure ADC rules as described in the
Step 3
Configure P2P protocol groups as described in the
Step 4
Configure behavioral traffic as described in the
Step 5
Configure SSL renegotiation as described in the
Step 6
Configure analyzers as described in the
Step 7
Configure the charging action as described in the
Step 8
Configure the rulebase as described in the
Step 9
Optional: Set EDR formats as described in the
Step 10 Configure the IP protocol and server port mapping for EDRs as described in the
Step 11 Configure the P2P events for generation of EDRs as described in the
Important:
Commands used in the configuration examples in this section provide base functionality to
the extent that the most common or likely commands and/or keyword options are presented. In many cases,
other optional commands and/or keyword options are available. Refer to the Command Line Interface
Reference for complete information regarding all commands.
other optional commands and/or keyword options are available. Refer to the Command Line Interface
Reference for complete information regarding all commands.
Creating the Active Charging Service
Use the following configuration example to create the ACS service:
configure
active-charging service <acs_service_name> [ -noconfirm ]
end
Important:
The
p2p-dynamic-rules protocol all
CLI command under Active Charging service is
deprecated, and not supported in 12.0 and later releases.
Configuring ADC Rules
Use the following configuration example to set the P2P detection protocols in the ACS and the rule definitions for each
P2P protocol.
P2P protocol.
Important:
The list of P2P protocols will be populated based on the currently installed plugin.
configure
active-charging service <acs_service_name>