Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Guide De Montage
Chapter 4 Using the Craft Port
40
4037424 Rev A
Note: If you have difficulty establishing communications with the transponder,
try changing the laptop IP address value to 192.168.100.2 and its subnet mask
value to 255.255.255.0.
try changing the laptop IP address value to 192.168.100.2 and its subnet mask
value to 255.255.255.0.
5 Press the Enter key. At the login prompt, enter the appropriate user name (the
default is cheetah) and press the Enter key. Next, enter the appropriate password
(the default is cheetah) and press the Enter key. The console prompt page
appears as shown in the following example.
(the default is cheetah) and press the Enter key. The console prompt page
appears as shown in the following example.
6
Console mode supports a number of commands that are used for
troubleshooting and debugging purposes. Providing a list and description of all
of the available commands would exceed the scope of this manual. Therefore, the
commands described in this section will be those found in the hms directory. For
additional information about the use of the console commands, contact Technical
Support using the contact information provided in Customer Support
Information (on page 79).
troubleshooting and debugging purposes. Providing a list and description of all
of the available commands would exceed the scope of this manual. Therefore, the
commands described in this section will be those found in the hms directory. For
additional information about the use of the console commands, contact Technical
Support using the contact information provided in Customer Support
Information (on page 79).
The following table provides a list of the commands in the hms section available via
console mode along with a brief description of each command.
console mode along with a brief description of each command.
Command
Description
devices
Displays the modules that have been discovered in the Fiber Node.
dumps
Toggles the serial dump feature on and off.
images
Displays the firmware image information.
rawio
Displays the raw input and output values from the transponder's two
processors.
processors.
smio
Displays the status monitoring IO values.
spidump
Toggles the spidump feature on and off.
spistats
Displays the SPI statistics.
status
Displays general transponder information, i.e., firmware version, IP
addresses, etc.
addresses, etc.