Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split 설치 가이드

 

40 

4037424 Rev A 

Note: If you have difficulty establishing communications with the transponder, 
try changing the laptop IP address value to 192.168.100.2 and its subnet mask 
value to 255.255.255.0. 

5  Press the Enter key. At the login prompt, enter the appropriate user name (the 

default is cheetah) and press the Enter key. Next, enter the appropriate password 
(the default is cheetah) and press the Enter key. The console prompt page 
appears as shown in the following example. 

 

Console mode supports a number of commands that are used for 
troubleshooting and debugging purposes. Providing a list and description of all 
of the available commands would exceed the scope of this manual. Therefore, the 
commands described in this section will be those found in the hms directory. For 
additional information about the use of the console commands, contact Technical 
Support using the contact information provided in Customer Support 
Information (on page 79). 

The following table provides a list of the commands in the hms section available via 
console mode along with a brief description of each command. 

devices 

Displays the modules that have been discovered in the Fiber Node. 

dumps 

Toggles the serial dump feature on and off. 

images 

Displays the firmware image information. 

rawio 

Displays the raw input and output values from the transponder's two 
processors. 

smio 

Displays the status monitoring IO values. 

spidump 

Toggles the spidump feature on and off. 

spistats 

Displays the SPI statistics. 

status 

Displays general transponder information, i.e., firmware version, IP 
addresses, etc.