Cisco Headend System Release 2.7 Guide De Montage
Chapter 2 Installing the Software
36
4023373 Rev B
Restarting Billing and Other Third-Party Applications
Contact your billing vendor to restart the billing interface. If you stopped any third-
party interfaces, restart those interfaces as well.
party interfaces, restart those interfaces as well.
What's Next?
The next action you take depends upon whether or not your system uses the
Regional Control System (RCS) option.
Regional Control System (RCS) option.
If your system uses the RCS option, go to Restarting RNCS Processes (on page
36).
36).
If your system does not use the RCS option, go to Complete System Validation
Tests (on page 39).
Tests (on page 39).
Restarting RNCS Processes
If you determined earlier that your system uses the RCS feature, use one of the
following methods to restart Remote Network Control Server (RNCS) processes at
each remote site in your RCS:
following methods to restart Remote Network Control Server (RNCS) processes at
each remote site in your RCS:
Use the siteCmd command to restart RNCS processes at all sites in your system.
Go to Restarting RNCS Processes at All Sites (on page 36).
Go to Restarting RNCS Processes at All Sites (on page 36).
Use the siteControl command to restart RNCS processes at each site in your
system, one site at a time. Go to Restarting RNCS Processes at One Site (on page
37).
system, one site at a time. Go to Restarting RNCS Processes at One Site (on page
37).
Restarting RNCS Processes at All Sites
1 Open an xterm window on the DNCS, and log on as the dncs user.
2 To restart RNCS processes at all sites in your system, type siteCmd –a lionnStart
1 Open an xterm window on the DNCS, and log on as the dncs user.
2 To restart RNCS processes at all sites in your system, type siteCmd –a lionnStart
and press Enter. The system prompts you to verify that you want to “start the
LIONN” (all RNCS processes at all sites).
LIONN” (all RNCS processes at all sites).
3 Type Y (yes) and press Enter to confirm that you want to restart the processes on
all sites in your system. The system informs you that it is starting LIONN
Applications (processes on all sites in your system), and displays the command
prompt for the DNCS user. If necessary, manually run the IPG collector, and
then go to Complete System Validation Tests (on page 39).
Applications (processes on all sites in your system), and displays the command
prompt for the DNCS user. If necessary, manually run the IPG collector, and
then go to Complete System Validation Tests (on page 39).
4 To exit, type x and then press Enter.
5 If necessary, manually run the IPG collector.
6 Go to Complete System Validation Tests (on page 39).
5 If necessary, manually run the IPG collector.
6 Go to Complete System Validation Tests (on page 39).