Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

 

136 

4039132 Rev B 

OverrideMacAddr 

A MAC address used instead of the actual hardware 
MAC address. Used when server hardware fails and is 
replaced by a new unit. 

Note: You must be service level to modify this 
parameter. 

STBCapacityAlarm 
Threshold 

Displays the alarm threshold for the total number of 
active STBs. 

MaxServiceGroups 

Displays the maximum number of service groups 
supported by the software. 

ServiceGroupSTBCapacity 

Displays the maximum number of STBs in a single 
service group supported by the software. 

DisplayMode 

Sets the web interface display mode, as follows: 

Normal - Only populated entries in tables are displayed. 

Config - All rows/entries of a table are displayed, 
allowing you to enter values into the displayed rows for 
configuration purposes. The server implements dynamic 
rows that exist if configured. The Config mode exposes 
all rows of a table allowing manual data entry into the 
table. This technique is used to create an entry in a table. 

MaxQAMChannels 

Displays the maximum number of QAM channels 
supported by the software. 

MaxSupportedSessions 

Displays the maximum number of sessions supported by 
the software. 

ConfigHashWidth 

The software uses a hash table to quickly locate sessions. 
This setting shows the compile-time hash table width. 

SessionUdpPortMin 

Minimum value for the assignment of UDP port numbers 
on Gigabit input ports. 

SessionUdpPortMult 

Multiplier used for the calculation of UDP port numbers. 

SessionUdpPortMax 

Minimum value for the assignment of UDP port numbers 
on Gigabit input ports. 

ServerName 

The name of the server. This name is used to form the 
name of log files. 

Note: This parameter must be populated if the 
Applications.SdvSM.Activity log.ActivityLogFormat is 
set to Comcast.