Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Adding and Deleting Service Groups to a USRM Using the Web Interface
4039132 Rev B
319
a On the Platform - ConfigManager - Resource Create page, enter a unique
resource name in the CreateName field associated with the device type you
want to create.
want to create.
Note: QAM names cannot contain spaces.
b Click Commit Changes.
c Repeat this for all resources to be added.
d Refresh the navigation tree. Either click the top-level USRM name or click
c Repeat this for all resources to be added.
d Refresh the navigation tree. Either click the top-level USRM name or click
the web browser refresh button.
Note: This causes the newly-added resources to display in the navigation
tree in the ResourceManager section.
tree in the ResourceManager section.
2 Read the QAM settings. (Cisco QAMs only.)
a Select the Resource Manager - QAMs - QAM <QamName> - Chassis page.
b Enter the IP Address of the QAM's management port in the CtrlIpAddress
b Enter the IP Address of the QAM's management port in the CtrlIpAddress
field and click Commit Changes.
Note: This causes the USRM to read the QAM settings (frequency, TSID, etc.)
via SNMP and place the information in the USRM tables.
via SNMP and place the information in the USRM tables.
c Select the Resource Manager - QAMs - QAM <QamName> - QAM Channels
page.
d Verify the QAM settings, particularly that the Service Type (SDV, VOD) and
Admin States are set properly.
3 Assign service groups.
a Select the Resource Manager - QAMs - QAM <QamName> - Output Ports
page.
b Enter the Service Group ID associated with each port, then set the Admin
State to InService and click Commit Changes.
c Select the ResourceManager - Service Groups:Config page and verify the
AdminState is set to InService. If not, set it.
d Verify that sessions are created as follows.
i Monitor the EventLog tail.
ii Check the Resource Manager - QAMs - QAM <QamName> - Sessions
ii Check the Resource Manager - QAMs - QAM <QamName> - Sessions
page for video and MCP sessions.
iii On the Applications - McmisServer - MCP Sessions page, verify that
mini-carousels are created.
iv For a graphical view of sessions, select either the Applications - SdvSm -
Service Groups/Bandwidth page and click QamGraphic or select the
ResourceManager - ServiceGroups:Graphics page and click
QamComposition for the desired service group.
ResourceManager - ServiceGroups:Graphics page and click
QamComposition for the desired service group.