Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

 

314 

78-4021139-01 Rev D 

Do you wish to enable extbr0 (eth0 Bridge Interface)? 
(yes/no)

 

Answer “yes” if you want to enable the first Ethernet device. If you answer 

“yes” to this question, you are prompted with question "b". 

Acquire extbr0 (eth0 Bridge Interface) info via DHCP? 
(yes/no)

 

Answer "yes" if you have a DHCP server you would like the machine to get 

its IP address from. If you answer “no”, you will be prompted with questions 

"c" and "d". 

Enter the IP address for extbr0 (eth0 Bridge Interface):

 

Answer this question with information provided by your network 

administrator. 

Enter the netmask for extbr0 (eth0 Bridge Interface):

 

Answer this question with information provided by your network 

administrator. 
Note: After answering these questions for extbr0, you are prompted for the 

same information for extbr1. Answer these questions as outlined above. 

Do you want to set a default gateway? (yes/no)

 

Answer "yes" if your network has a central server that routes all of the 

network traffic. If you answer "yes" to this question, you are prompted with 

question "f". 

Enter the IP address of the default gateway:

 

Enter the IP address of the central server that routes your network traffic. 

Do you want to set a nameserver? (yes/no)

 

Answer “yes” if you have a nameserver you would like the USRM Server to 

use. If you answer "yes" to this question, you are prompted with question "h". 

Do you want to set a hostname? (yes/no)

 

Answer "yes" if you would like the machine to have a unique name on your 

network. If you answer "yes," you will be prompted with questions "J" and 

"k. 

Enter the hostname:

 

Enter the domainname:

 

Result: The system writes the USRM interfaces config file and then prompts 

you with the following choices: 

Setup complete. Would you like to:

 

(1) Exit

 

(2) Restart Networking

 

(3) Reboot

 

 Make a selection: