Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 4 Operation
316
78-4021139-01 Rev D
5 Select the USRM Server Management page from the navigation tree at left.
6 For the desired virtual USRM(s), select Restart Networking in the Management
6 For the desired virtual USRM(s), select Restart Networking in the Management
Action dropdown menu, and then click Commit Changes to apply.
7 After 30-60 seconds, the virtual USRM(s) should be reachable at the configured
IP address(es).
UCS USRM Startup Procedure
The UCS USRM is designed to run all virtual USRMs automatically on startup. If one
or more virtual USRMs is not running, follow these steps to start up and run the
virtual USRM.
1 Make sure that you have completed the initial setup procedure as described in
1 Make sure that you have completed the initial setup procedure as described in
Virtual UCS USRM Setup Procedure (on page 315).
2 Connect to the USRM Web interface and log in to the USRM as user admin using
the default password admin.
3 Select the USRM Server Management page from the navigation tree at left.
4 For the desired virtual USRM(s), choose the desired Management Action from
4 For the desired virtual USRM(s), choose the desired Management Action from
the dropdown menu (typically Startup) and then click Commit Changes to
apply.
5 After 3-5 minutes, the USRM(s) should be available. Reload the page as needed
to update the status.
Virtual USRM Console
The console for a virtual USRM can be accessed via SSH after configuring the
network if the virtual USRM is running and fully loaded. For troubleshooting
purposes, you can also connect to the console of the virtual USRM using the
following procedure.
1 Access the virtual USRM using SSH and log in as user root with the default
1 Access the virtual USRM using SSH and log in as user root with the default
password generic.
2 Run the following command, replacing 01 in the example shown with the actual
number of the virtual USRM (01-08) if necessary:
virsh console usrm-01
3 Press Enter again to activate the console.
4 When finished, type Ctrl-] to leave the console for the virtual USRM.
4 When finished, type Ctrl-] to leave the console for the virtual USRM.