Manualsbrain.com
  1. Manuels
  2. Marques
  3. Cisco
  4. Model 6109 6 MHz Off-Air Reference (NTSC)
  5. Guide De Montage

Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage

Télécharger
Page de 500
 
Chapter 4    Operation 
 
 
 
364 
78-4021139-01 Rev D 
Offered Programs - Offer State by Service Group 
Beginning with USRM 1.6.1, offered programs can be configured to be either static or 
dynamic per service group. A new Web UI page is introduced titled Offered Progs 
OfferState and is located in the Navigation Tree under Applications.SdvSm. 
There are three states available: 
 
Use Base (default). When assigned this state, the offered program uses the offer 
state of the program in the Offered Progs Base Table (default = dynamic). 
 
Static. When assigned this state, the offered program is always available in the 
service group and is not subject to reclamation. 
 
Dynamic. When assigned this state, the offered program is treated as a normal 
switched channel. This setting is only needed when the program in the Offered 
Progs Base table is set to static, but a particular service group requires the 
program to be dynamic. 
Settings 
You can make Offered Progs OfferState settings either via the Web UI or via config 
file. The procedures in this section describe the Web UI interface and settings. 
You must access two pages to provision Offer States: 
 
Applications.SdvSm.Configuration 
 
Applications.SdvSm.Offered Progs OfferState 
Note: You must have Administrator privileges to set Offered Progs OfferState 
parameters. 
To Configure Server Display Mode 
Important: The DisplayMode parameter on the Applications.SdvSm.Configuration 
page must be set to Config in order to make settings on the Offered Progs 
OfferStates page. 
The USRM implements tables with dynamic rows. In normal use, only rows with 
defined entries are displayed. The DisplayMode parameter lets you enable the 
display of all rows of a table, including empty entries. This mode allows you to 
directly configure an entry in a table. 
The DisplayMode parameter is located on the Applications.SdvSm.Configuration 
page of the USRM Web interface. 
Note: To set a program offer state, this parameter must be set to Config. Once 
configuration is complete, set the display mode back to Normal.