Руководство По Установке для Cisco Model 6109 6 MHz Off-Air Reference (NTSC)
Chapter 4 Operation
364
78-4021139-01 Rev D
Offered Programs - Offer State by Service Group
Beginning with USRM 1.6.1, offered programs can be configured to be either static or
dynamic per service group. A new Web UI page is introduced titled Offered Progs
OfferState and is located in the Navigation Tree under Applications.SdvSm.
There are three states available:
There are three states available:
Use Base (default). When assigned this state, the offered program uses the offer
state of the program in the Offered Progs Base Table (default = dynamic).
Static. When assigned this state, the offered program is always available in the
service group and is not subject to reclamation.
Dynamic. When assigned this state, the offered program is treated as a normal
switched channel. This setting is only needed when the program in the Offered
Progs Base table is set to static, but a particular service group requires the
program to be dynamic.
Settings
You can make Offered Progs OfferState settings either via the Web UI or via config
file. The procedures in this section describe the Web UI interface and settings.
You must access two pages to provision Offer States:
You must access two pages to provision Offer States:
Applications.SdvSm.Configuration
Applications.SdvSm.Offered Progs OfferState
Note: You must have Administrator privileges to set Offered Progs OfferState
parameters.
To Configure Server Display Mode
Important: The DisplayMode parameter on the Applications.SdvSm.Configuration
page must be set to Config in order to make settings on the Offered Progs
OfferStates page.
The USRM implements tables with dynamic rows. In normal use, only rows with
The USRM implements tables with dynamic rows. In normal use, only rows with
defined entries are displayed. The DisplayMode parameter lets you enable the
display of all rows of a table, including empty entries. This mode allows you to
directly configure an entry in a table.
The DisplayMode parameter is located on the Applications.SdvSm.Configuration
The DisplayMode parameter is located on the Applications.SdvSm.Configuration
page of the USRM Web interface.
Note: To set a program offer state, this parameter must be set to Config. Once
Note: To set a program offer state, this parameter must be set to Config. Once
configuration is complete, set the display mode back to Normal.