Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Appendix B
USRM Server Replacement
446
78-4021139-01 Rev D
Introduction
In the event of failure of the USRM server, use the following procedures to start and
configure the new server hardware once it is installed.
The process of starting up a replacement USRM server involves four main steps:
The process of starting up a replacement USRM server involves four main steps:
Power up the server
Perform initial server setup
Initialize the primary server
Start the server in Supervised mode
The following sections describe these procedures in detail.
For Assistance
For assistance with any of the procedures described here, contact your Cisco
Technical Assistance Center (TAC). See Customer Information (on page 421) for
contact information.