Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Appendix B
USRM Server Replacement
452
78-4021139-01 Rev D
Start the Server in Supervised Mode
Complete the following steps to start the USRM server in Supervised mode.
1 Start system logging on primary server as follows:
1 Start system logging on primary server as follows:
a Open a SSH session to the USRM primary server.
b Type the following command at the system prompt, and then press Enter:
b Type the following command at the system prompt, and then press Enter:
a. cd /opt/usrm/EventLog
b. tail -f today’s date_000000.txt Example:(12Aug2009_000000.txt )
2 Restart the USRM software with the –supervised –d options as follows:
a Open a second SSH session to the USRM primary server.
b Type cd /opt/usrm and then press Enter to navigate to the USRM directory.
c Type ./usrm –supervised -d and then press Enter to restart the software.
b Type cd /opt/usrm and then press Enter to navigate to the USRM directory.
c Type ./usrm –supervised -d and then press Enter to restart the software.
Note:
–
–
There are 2 dashes before the "supervised" operand and 1 dash before the
"d" operand.
–
Allow the software to completely start before continuing with this
procedure.
3 Open a Web browser to the USRM Server. When you log on, you will be greeted
with a dialog informing you that your password has expired. Re-enter and
confirm your password.
4 Verify that the USRM primary server has taken control from the standby server
and is ready to act as a primary server, as follows:
a Click ERM/SdvSm at the top of the navigation tree.
b Click System.
a Click ERM/SdvSm at the top of the navigation tree.
b Click System.