Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Guide De Montage
Chapter 3 USRM Web Interface
174
78-4021139-01 Rev D
Parameter
Description
NumOutputPorts
Number of output ports on the device. This is a service
level parameter in the RFGW1 model, and is located on
the Configuration page in the GQI model.
NumChansPerPort
Number of channels per port on the device. This
parameter is located on the Configuration page in the
GQI model.
AlarmThreshold
The alarm threshold for an edge device. When an edge
device fails for this many consecutive attempts, the edge
device status is set to Alarm. Not applicable in the
RFGW1 model.
FailThreshold
The failure threshold for an edge device. When an edge
device fails for this many consecutive attempts, the
resource state is set to the Failure state. Not applicable in
the RFGW1 model.
Note: You must be service level to modify this
Note: You must be service level to modify this
parameter.
Protection
Sets protection of the device to Manual or Automatic.
When set to Automatic, a failed QAM will be protected
by a normal QAM in the same service group.
This parameter is dependent on the
This parameter is dependent on the
ResourceManager.Configuration.ResourceProtection
setting, and is located on the Configuration page in the
RFGW1 model.
CtrlIpAddress
Configures/displays the IP address of the management
port of the QAM chassis.
Cost
(D6QAM only)
The cost field reported from D6.
DataIpAddress
Configures the IP address of the data port of the QAM
chassis. This parameter is located on the Data GbE Ports
page on the GQAM, and on the GbE Ports page on the
RFGW1 models. On the GQI and D5 models, it is located
on the Edge Inputs page.
CtrlMacAddress
(GQAM and RFGW1)
The MAC address for the device.
SubnetMask
(GQAM only)
The subnet mask value for this device.
GatewayIPAddr
(GQAM only)
The gateway IP address for this device.
ConfigFile
(GQAM only)
The name of the device configuration file.
ServiceState
(D6QAM only)
The service state for a D6 device.