Cisco Cisco ACNS Software Version 5.5

See the 

information about maintaining and administering the WAE network module.

See the 

 for a list of new and modified IOS commands used 

to configure the WAE network module.

This section contains the following topics:

The tables in these sections list only the most common router and network module commands. The tables 
group commands by the configuration mode in which they are available. If the same command is 
available in more than one mode, it may act differently in each mode.

To view a complete list of available commands, type ? at the prompt, as shown in the following example:

Router(config-if)# ? 

To view a complete list of command keyword options, type ? at the end of the command, as shown in 
the following example:

Router# service-module integrated-service-engine ?

Enter configuration commands on the module as needed.

Configuration command choices are similar to those 
commands that are available on the router. Access global 
configuration mode by using the configure terminal 
command. Enter configuration commands. Then exit global 
configuration mode with the exit command and save your 
new configuration with the write command. 

SE-Module# configure terminal

SE-Module(config)#

.

.

.

SE-Module(config)# exit

SE-Module# write

Close the service module session and return to the router 
CLI.

The service module session remains active until you clear it 
in the next step. While it remains active, you can return to it 
from the router CLI by pressing Enter.

Press Ctrl-Shift-6 x.

From the host router CLI, clear the service module session 
for the specified module. When prompted to confirm this 
command, press Enter.

slot/0 

Router# service-module