Cisco Cisco Prime Network Services Controller 3.0 Guide De Montage
• To assign a VSG, an available VSG must be registered in Prime Network Services Controller. For more information, see
4—Verifying Service VM Registration, on page 19
.
• To assign a VSG pool, a VSG pool must have at least one available VSG.
• To instantiate a VSG service device, a VM service image must be imported and VM Manager must be configured in Prime
Network Services Controller. For more information on importing service images, see
page 28
.
Procedure
Step 1
Choose Resource Management > Managed Resources > root > tenant > Compute Firewalls.
Step 2
In the General tab, click Add Compute Firewall.
The Add Compute Firewall Wizard opens.
The Add Compute Firewall Wizard opens.
Step 3
In the Properties screen, supply the information as described in
Properties Screen, on page 29
, then click Next.
Step 4
In the Service Device screen, select the required VSG service device as described in
Service Device Screen, on page 30
,
then click Next.
Step 5
(Instantiate option only) If you instantiate a VSG service device from an image, do one or both of the following in the
Placement screen, then click Next:
Placement screen, then click Next:
• Navigate to and choose the host or resource pool to use for the VSG instance.
• If you enabled high availability, either check the Same as Primary check box, or navigate to and choose the host
or resource pool to use for the secondary VSG instance.
Step 6
In the Interfaces screen, configure interfaces as follows, then click Next:
• If you assigned a VSG, enter the data IP address and subnet mask.
• If you assigned a VSG pool, enter the data IP address and subnet mask.
• If you instantiated a VSG service device without high availability, add management and data interfaces.
• If you instantiated a VSG service device with high availability, add management, data, and HA interfaces.
For field-level help when configuring the interfaces, see the online help.
Step 7
In the Summary screen, confirm that the information is correct, then click Finish.
Properties Screen
Description
Field
Compute firewall name.
This name can contain 1 to 32 identifier characters. You can
use alphanumeric characters including hyphen, underscore,
dot, and colon. You cannot change this name after it is created.
use alphanumeric characters including hyphen, underscore,
dot, and colon. You cannot change this name after it is created.
Name
Compute firewall description.
Description
29