Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

To monitor reporting data from your Email Security appliances on the Security Management appliance, 
view the Email > Reporting > Reporting Data Availability page. 

From the Reporting Data Availability page, you can view the percentage of reporting data that the 
Security Management appliance received from your Email Security appliances over a specified period 
of time. A bar chart indicates the completeness of the data received during the time range. 

You can monitor reporting data availability for the preceding day, week, month, or year. If the Security 
Management appliance received less than 100% of the reporting data from the Email Security 
appliances, you can tell immediately that your data may be incomplete. Use the data availability 
information to validate reporting data and to troubleshoot system problems.

If you have had to replace an Email Security appliance due to a hardware failure or other reasons, the 
data from the replaced Email Security appliance will not be lost, but the data will not be displayed 
correctly on the Security Management appliance.

To monitor reporting data from your Web Security appliances on the Security Management appliance, 
view the Web > Reporting > Data Availability page. 

From the Data Availability page you can update and sort data to provide real-time visibility into resource 
utilization and web traffic trouble spots.

.

In the Web Reporting Data Availability window, Web Reporting will show disabled only if both Web 

Reporting and Email Reporting are disabled.

All data resource utilization and web traffic trouble spots are shown from this page. By clicking on one 
of the listed Web Security appliance links, you can view reporting data availability for that appliance. 

You can monitor reporting data availability for the preceding day, week, month, or year. If the Security 
Management appliance received less than 100% of the reporting data from the Web Security appliances, 
you can tell immediately that your data may be incomplete. Use the data availability information to 
validate reporting data and to troubleshoot system problems. 

If data availability is used within a scheduled report for URL Categories, and there are gaps in data for 
any of the appliances, the following message is displayed at the bottom of the page: “Some data in this 
time range was unavailable.” If there are no gaps present, nothing appears.

See the 

 for more information on the Data Availability page on the Web Security 

appliance.