Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

In this example, a file named 

changed.config.xml

 is uploaded and the changes are committed: 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 2

Enter the name of the file to import:

[]> changed.config.xml

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

In this example, a new configuration file is pasted directly at the command line. (Remember to press 
Ctrl-D on a blank line to end the paste command.) Then the System Setup Wizard is used to change the 
default hostname, IP address, and gateway information. (For more information, see 

.) Finally, the changes are committed. 

mail3.example.com> loadconfig

1. Paste via CLI

2. Load from file

[1]> 1

Paste the configuration file now. Press CTRL-D on a blank line when done.

[The configuration file is pasted until the end tag </config>. Control-D is entered on a 

Values have been loaded.

Be sure to run "commit" to make these settings active.

mail3.example.com> commit

Please enter some comments describing your changes:

[]> pasted new configuration file and changed default settings

View the amount of disk space allocated to each of the Security Management appliance’s monitoring 
services at Management Appliance > System Administration > Disk Management. 

You can allocate available disk space among the features that your organization uses, up to the maximum 
available.