Samsung RFG28MESL Manuel D’Utilisation

operating 

02

 OPERA

TING

1.  Turn ON the main water supply

and supply water from water
supply line.

2.  Run water through the

dispenser until the water runs
clear (approx. 6 to 7 minutes).
This will clean the water supply system and
remove air from the lines.

3.  Additional flushing may be required in some

households.

4.  Open the Refrigerator door and make sure there

are no water leaks coming from the water filter.

Be sure to flush the dispenser thoroughly,
otherwise water may drip from the dispenser.
This means that there is still air in the line.

IMPORTANT : The pressure of the water supply
coming out of a reverse osmosis system going to
the water inlet valve of the refrigerator needs to be
between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to be
a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
•  Check to see whether the sediment filter in the

reverse osmosis system is blocked. Replace the
filter if necessary.

•  Allow the storage tank on the reverse osmosis

system to refill after heavy usage.

•  If your refrigerator has a water filter, it may

further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.

If you have questions about your water pressure, call
a licensed, qualified plumber.

DA99-03404E-12.indb   21

2016. 12. 2.   �� 4:33