Samsung SRF677CDBLS Manuel D’Utilisation

 

setting up

When moving your refrigerator 

To prevent floor damage, be sure the front 
adjusting legs are in the up position (above 
the floor). Refer to ‘Adjusting the Level’ in 
the manual (on page 19).

Flat-blade screw 
driver(-)

Control Lever

FLOORING

For proper installation, you must place this 
refrigerator on a level, hard surface that is the 
same height as the rest of the floor. This surface 
should be strong enough to support a fully loaded 
refrigerator.
To protect the finish of the flooring, cut a large 
section of the cardboard carton and place it under 
the refrigerator where you are working. When 
moving the refrigerator, you need to pull and push 
it straight forwards or back. Do not wiggle it from 
side to side.

REMOVING THE 
REFRIGERATOR DOORS

For some installations you need to remove the 
fridge and freezer drawers so you can move the 
refrigerator to its final location. 

the doors/drawer if you don’t need to. If you 
do not need to remove the refrigerator doors, go 
to Adjusting the Level on page 19. If you need to 
remove the doors. continue below.
Before removing the door/drawer, make sure you 
read the following items:

Disconnect power to the refrigerator 
before removing the door or drawer.

•  Be careful not to drop, damage, or 

scratch the doors/drawers while 
removing them.

•  Use care when you remove the doors/drawers. 

The  doors are heavy and you could injure 
yourself.

•  Reattach the doors/drawers properly to avoid: 

 

- Moisture from air leakage.

 

-  Uneven door alignment.

 

- Wasting energy due to improper door seal.

Disassemble the refrigerator doors

Be careful not to drop and scratch the
doors while removing them.

Required Tools (Not provided)

You need the following tools to complete the 
installation of your refrigerator:

Philips 

screwdriver(+)

Flat-blade screw 

driver(-)

Socket wrench 

(10 mm)

Pliers

Allen wrench  

(5 mm)

DA68-02916A (EN)-12.indd   16

2016. 3. 24.   �� 7:18